The mortar spraying machine is suitable for reinforcement, leveling, painting and pumping. Mortar spraying machine can be used for plastering of ordinary mortar on internal and external walls, smoothing plaster, thermal insulation mortar, bonding mortar, lime plastering, repairing plastering, surface ash, sticking ceramic tiles and filling mortar. This model is equipped with a screw pump specially developed for the Chinese market. You can use both fresh and premixed mortar at the same time. By replacing the nozzle and screw pump, the gas volume can be adjusted. Most common mortar and special mortar can be used to achieve one machine and multiple uses. Different materials can be used in conjunction with different mixers to achieve mixing and spraying. Before the installation, the necessary items for painting must be prepared. The necessary items for painting are paint and thinner, paint mixer, weighing equipment, spraying machine and supporting equipment, paint and coating testing equipment, etc. In addition to this, it is necessary to carry out the preparation of multi-functional paint and machine debugging.
Usage of mortar spraying machine: 1. Before starting each shift, press the hand pump several times to inject oil into the transmission parts. 2. After connecting the power supply, first electric main motor to check whether the direction of rotation of the rubber spiral is consistent. 3. Connect the conveying hose and spray head, add 5L of clean water to the hopper, start the motor to pump the clean water to wet the hopper, pump body and conveying hose, and stop the pump after pumping most of the water. 4. Add putty or paint into the hopper to start spraying (the air compressor should be started and the air valve should be opened first). 5. It is strictly forbidden to run idly in the hopper without material and water. 6. After the work is completed, the remaining material in the hopper must be drained, and enough fresh water should be injected into the hopper, the hopper should be cleaned, and the pump should be turned on to clean the hose and the spray head until all the water is pumped out to avoid the remaining material in the hose. Solidify, block the hose and spray head. 7. If the shutdown time is too long, wipe the machine clean and remove the booster screw. After oiling, keep it properly and reinstall it when using it.
The connection of the feed pipe of the mortar spraying machine can be rotated for easy operation. High construction efficiency and good quality. Small size, easy to carry on site, and low cost of accessories, simple maintenance of cement mortar spraying machine. The mortar spraying machine is easy to use, fast, save materials, labor, and save money.
