The mortar spraying machine basically has no floor dust, water and material, which can greatly reduce the cost, simple operation, no scaffolding, no moving equipment, no repairing and stubble, both the male and female corners and the roof can be sprayed freely, with fast speed and high efficiency , Labor intensity is low, a multifunctional spraying machine can easily spray 1.5 cm thick cement 200 square meters per hour. Wall brushing shotcrete, aerated block wall brushing shotcrete can easily achieve more than 10,000 square meters per day.
Mortar spraying machine to the main line, turn on the electric box gate, and start the main motor. If the main motor does not start and the hot line is reversed, directly swap the middle of the hot line and either side of the line. If the connected line is correct, the machine can start normally. Start the first step (turn on the air pump first). If the machine is normal, put the cement slurry to lubricate the machine and pipes, then discharge the material. After discharge, turn on the air pump for 3 seconds. Turn on the main motor and spray normally. The spray gun must be freely sprayed to the wall about 10 cm from the wall during normal work. After the main motor stops for 3 seconds, stop the air pump, pour water and start the flushing hopper. There is a sewage treatment port under the hopper that can be opened directly. After the sewage flows out, screw the sewage port to work. Finally, please take down the main line to prevent unintentional empty machine operation from causing the screw and rubber sleeve to solidify; before mechanical operation, I hope friends can read and understand the operation process.
The mortar spraying machine introduced by our company has large flow and high pressure, which overcomes the above-mentioned defects. The density of the mortar far exceeds the prescribed standard, avoiding troubles caused by quality, construction period, and cost.
