The mortar spraying machine can not run all normal should how the actual operation, it is every mortar spraying machine operators are very concerned about a problem. The emergence of the mortar spraying machine, has already further improved the putty batch project construction efficiency, at present many construction units choose the mortar spraying machine to carry out the plastering project construction. Mortar spraying machine belongs to the industrial equipment, long-term application is very easy to lead to some common problems, if the solution is not immediately, will endanger the progress of the project, so we must carefully complete the common problems of the mortar spraying machine. For example, in the engineering construction, the production of mortar spraying machine can not run normally, this at that time in the spraying work is no doubt can not be carried out. So, encounter mortar spraying machine can't everything run normally how to do?
First of all, the status of the power supply system of the switch power supply of the mortar spraying machine should be checked: the connection head is firm; Power switch touch is inseparable; The fuse is not broken; Three - phase power supply system is not the same. If there is short circuit, loose, fuse break, break phase, should find out the cause and immediately repair.
The second check is not the centrifugal pump itself equipment fault, the common reason is: the filling is too tight or the centrifugal impeller and pump shell between the dirt stuck dead and blocked; Pump shaft, rolling bearing, leakage reduction ring rust stop; Pump shaft is more serious bending and so on. Clearing method: release the pressure filling material and feed the diversion channel; Remove the pump shell to eliminate dirt and rust; Remove the pump shaft effect or remove the new pump shaft.
That is to say, the mortar spraying machine can not all normal operation should be how the actual operation of the wonderful content, I believe that we have read the solution to this problem has a certain grasp. During the construction of the project, the mortar spraying machine can not all normal operation, can say it is a very serious problem, because the mortar spraying machine can not run, the mortar spraying work is not to speak of. Therefore, for the solution of this problem, the operator of the mortar spraying machine must be very good grasp, so that can be in common fault generation, with a fast rate to solve the difficulty, for all normal engineering construction to obtain time.
