Earlier we introduced what a automatic mortar spraying machine is. The automatic mortar spraying machine is easy to operate, does not require scaffolding, does not need mobile equipment, and does not need to repair stubble. Both the yin and yang corners and the roof can be sprayed freely, shortening the construction period, improving progress, and saving Expenditure on the cost of frame materials. However, the sprayer is easy to accumulate slag, which causes problems. So how should the mortar sprayer be checked and maintained on a daily basis? Let's take a look today.
The first is pre-operation inspection and maintenance of mortar spraying machine
1. Check the electrical equipment: including the inspection of the motor, power supply and transmission lines, and electrical control box, and check whether each switch is in the prescribed state.
2. Forcibly refuel the hand pump several times.
3. Check the hopper for any debris and slag.
4. Check that the spraying hoses, nozzles and air ducts are unobstructed.
5. Check if the equipment is normal by air transportation.
6. The setting of wind pressure and wind flow is caused by the looseness of the wind pressure switch parts during transportation, and the pressure spring should be readjusted.
(II) Inspection and maintenance during mortar spraying machine shot blasting
1. Check whether the electrical equipment is operating normally and the motor temperature is normal.
2. Check if there are any problems with the sealing and fixing of hoses, nozzles and air ducts.
3. Check whether the joint is sealed and fixed. And wind pressure, air volume and working conditions.
(3) All bolts, nuts, and screws must be regularly checked for looseness, and tightened in time if found loose
(IV) Maintenance after automatic mortar spraying machine operation
1. Be sure to pay attention to the cleaning of hoses, ducts, nozzles and equipment after operation.
2. Turn off the power to the electrical equipment, close all valves, and check whether there is any damage in all parts.
3. Remove the pressurized nails and rotor, and reassemble after cleaning.
