The new putty mortar spraying machine adopts advanced screw pressurization technology, can spray mortar fireproof material, refractory material, mortar spray machine where there is, the head mortar spray pump which is not affected by regional and environmental environment and spray surface shape has superior quality. Compared with the manual powder wall plastering and the powder wall machine previously introduced in the market, the head mortar spraying machine has the following advantages.
1, basically no floor ash, save water, save materials, can reduce the cost of more than 20%. Head mortar spraying machine puzzle
2, the operation is simple, no need to take the tripod, no mobile equipment, can be freely on/off, insulation mortar spraying machine manufacturers, no need to repair the raft, yin and yang angle, roof, can be freely sprayed, shorten the construction period, improve the progress, and Savings on the cost of the frame material.
3, fast, high efficiency, labor intensity, a head mortar spraying machine can easily spray 150 square meters per hour, remove the preparation time, work 8 hours a day calculation, can spray more than 1000 square meters, quite 20 skilled workers hard work * The amount of work.
New putty mortar spraying machine common fault handling:
1. During the work, suddenly stop automatically, the possible reasons are:
A: Sudden power failure at the construction site. If the power supply will not be restored within a short period of time, the power supply, the pump core and all accessories must be removed and cleaned. When disassembling the conveying pipe, the bag must be covered with a bag or other items to prevent the moment from being released, the pressure inside the pipe is suddenly released, and the mortar is in danger.
B: The motor is overloaded. Check if the fuse is blown.
2. If the slurry is too dry or the shutdown time is too long and it is not cleaned, it may cause a blockage failure. A blockage fault is also one of the causes of overload. When this happens, the blockage must be cleared. Turn off the power first, do not immediately disassemble the spray or transport hose, otherwise the huge pressure inside the pipe will be released from the disassembly, and the explosion of sand will be dangerous.
A: Turn the power supply to the reverse direction.
B: Press the button to turn on the machine and turn the machine for about 30 seconds to reduce the pressure inside the pipe.
C: Remove the spray and clean it. Check if the nozzle is blocked.
D: Turn the power switch to forward rotation and turn it on.
